Clutch: Sliders

MTC Engineering's patented Slider technology

1.	Can I back the Slider studs out to gain more adjustment?
2.	Can I dyno my bike with the slider clutch installed?
3.	Can I leave from an idle with a Slider clutch?
4.	Can I ride my MTC slider equipped bike around the pits or back from a run?
5.	Can my 6mm slider studs be upgraded to 8mm studs?
6.	Doesn't adding weight to the arms and readjusting the stall speed cancel each other out?
7.	How can I tell which slider springs I have?
8.	How critical is basket endplay on a slider?
9.	How do I adjust the air gap on my slider?
10.	How do I adjust the stall speed of my MTC slider clutch?
11.	How do I check my basket endplay?
12.	How do I measure the air gap on my Slider?
13.	How many RPM should there be between the 2-step box and the stall speed of my slider?
14.	How should I conduct my burnout with a Slider?
15.	Is there a maximum height that I can set the anodized nuts at on the MTC slider?
16.	My slider clutch won't disengage at the end of the run what happened?
17.	My slider isn't reacting properly, what could be wrong?
18.	What about dry hops?
19.	What is meant by 'Stall Speed'?
20.	What is the correct procedure for installing the 3pc bearing?
21.	What is the ideal engagement RPM for a MTC slider?
22.	What is the minimum height to which I can set the slider hat springs?
23.	What oil should I run with my slider clutch?
24.	What should I do after making a spring height adjustment on my slider clutch?
25.	What should the air gap on my slider clutch be?

<< Start < Prev 1 2 Next > End >>

Performance Products
Street/Strip V-Twin/Metric